L9110 Dual-Channel H-Bridge Motor Driver Module for Arduino (Works with Official Arduino Boards) Overview:- Quantity: 1
- Color: Black
- Material: PCB board
- Dual L9110S chipset motor driver
- Input voltage: 2.5V~12V
- Current: 800mA
- Can drive two DC motors, and a 4-wire 2-phase stepper motor
- Great for DIY project
Dimensions: 1.22 in x 0.87 in x 0.47 in (3.1 cm x 2.2 cm x 1.2 cm)
Weight: 0.25 oz (7 g)
This H-bridge Motor driver works as it should. Despite some drawbacks, it does what it has to do. I used it for my differential Drive RC robot. Voltage range is quite versatile. The only problem I found is the heat problem...
Very good motor controller. Works without any problems with Raspberry Pi Handles a good amount of amps to drive large motors. It would be better if the centre holder hole would be more. It can feel a bit unstable this way....
Motor driver on the cheap, really small board, perfect for small robots. Easy to connect with Arduino and protoboard-friendly. Limited to 800mA, meaning each motor must max under 400mA (or one stepper at 800mA)or you can I...
Does its job. This module is most useful because you can drive two DC motors or one stepper motor. I chose to just drive one DC motor, and it worked great. Look up the wiring in the forum. Can't power higher-current Make a...
Motor driver on the cheap, really small board, perfect for small robots. Easy to connect with Arduino and protoboard-friendly. Limited to...
Does its job. This module is most useful because you can drive two DC motors or one stepper motor. I chose to just drive one DC motor, it...
This H-bridge Motor driver works as it should. Despite some drawbacks, it does what it has to do. I used it for my differential Drive RC...
